SECTION 1
Getting Started
PEN*KEY
R
6200/6300 Hand-Held Computer Programmer’s Reference Guide 1-7
System Configuration
Minimum Development Configuration
Note that the following paragraphs apply to the standard configuration for the
6200 or 6300 Series computer; but keep in mind that both of these computers
can be configured to meet your specific needs. For example, additional RAM can
be obtained to bring the total RAM up to the maximum capability.
The following constitutes the configuration items needed for a minimum
development, except for items 4 and 5, which are only useful if you do not have a
docking station.
1. A 6200 or 6300 Series computer, with the minimum number of megabytes
of system RAM (as specified in the
Introduction to the 6200 and 6300 Series
Computers
paragraph).
2. DOS or Windows toolkit.
3. Main and backup batteries; at least one of each.
4. One 2 MB or 4 MB SRAM card. You need at least one 2 MB SRAM card,
which is useful when you need to update the flash software. For larger
storage, SanDisk flash memory cards are available.
5. PC Card reader/writer (for example, Databook card readerĆwriter or
notebook computer that can read/write PC Cards).
6. NULL modem cable for connecting the PEN*KEY dock to a PC.
7. Cable for connecting the PEN*KEY dock to a serial printer, or to a 4800
Series or 6800 Series Printer (if printing is required).
8. Single dock with wall charger.
Sample Configuration Files
The configuration files, CONFIG.SYS and AUTOEXEC.BAT (for 6300 Computer)
and the CONFIG.SYS and ROMINIT.BAT (for the 6200 Computer), are required
for an appropriate environment for the 6200 and 6300 Series computers.
For examples of configuration files for these computers, see
Appendix A, Sample
Configuration Files
.
"
NOTE:
The name SunDisk has been changed to SanDisk.
1. Getting Started
