SECTION 3
Supporting Windows Applications
3-12 PEN*KEY
R
6200/6300 Hand-Held Computer Programmer’s Reference Guide
Errors During Installation
The following messages may be displayed in a dialog box if errors occur while
NORAPM.DLL is initializing:
"
APM BIOS not found!
"
Could not connect to APM BIOS!
"
Could not disable APM BIOS!
"
Could not allocate a timer for polling APM BIOS!
"
Could not enable power management of serial ports!
"
Could not load multimedia extensions!
"
Could not install system activity monitor!
Battery Status
The following messages are displayed in a dialog box when the warning
condition occurs. These messages are not displayed again until the interval set
by the
MsgRepeatMinutes
entry in
SYSTEM.INI (page 3Ć10) is reached and the
condition persists.
"
Main battery is low!
"
Only <0 . . 60> minutes of battery life remaining!
"
Only <0 . . 60> seconds of battery life remaining!
"
Power failure!
"
Dead or missing backup battery!
Suspend Errors
These messages appear in a dialog when you press the suspend/resume switch
and the system cannot suspend, because external charge is present or because a
Windows application, driver, or DOS TSR refused the suspend request.
"
System does not suspend while charge is applied
"
An application or driver is refusing to suspend
Event Messages
The following messages appear in a dialog box whenever the
ApmEventDialogs
entry in SYSTEM.INI (page 3Ć11) is set to 2" or above. These messages are
intended for power management debugging. See the
Standard APM Event Codes
paragraph, on page 3Ć16, for APM event code descriptions.
"
APM Event <Hex APM Event ID>
"
APM OEM Event <Hex OEM
Event ID
>
"
Time updated from <code> D/M/Y H:M:Sć>D/M/Y H:M:S
"
Backlight Timeout
"
Suspend Timeout
3. Windows
Applications
