14
Intermec EasyCoder 201 II – Technical Manual
MADE IN SWEDEN
Thermal Printer 201
Model #
1-201011-11
Serial #
115-230V 2.6-1.3A 50-60Hz
INTERMEC PRINTER AB
MADE IN SWEDEN
50105
This equipment complies with the requirements for a Class A computing device in FCC Rules
Part 15 Subpart J. Operation of this device in a residential area may cause harmful interference
requiring the user to take whatever steps may be necessary to correct the interference.
UL
LISTED 65B5
R
N309
LR67809
V
D E
geprüfte
Sicherheit
F 5
F 4
F 3
F 2
F 1
P o w e r
E r r o r
R e a d y
P a u s e
S e t u p
F e e d
E n t e r
7
4
1
.
8
5
2
0
9
6
3
C
EasyCoder
2 01
IIE
❑
Make sure that the printer is set for the correct voltage by
checking the voltage switch-over on the printer's rear plate.
❑
Fit the mains cord, which is included in the delivery, into the
mains receptacle. Connect the other end of the cord to a
grounded wall socket. To avoid interference from noise, surges
and spikes, a dedicated line is preferred. If no such line is
available, avoid lines to which electric motors, refrigerators and
similar devices are connected.
❑
The power can be turned on/off by means of the main switch
situated immediately above the mains receptacle. The “Power”
LED on the printer's front console indicates when the power is
on.
Mains Connection
INSTALLATION, cont'd.
Power On LED
Mains Receptacle
Main Switch
Voltage Switch-Over