Chapter 2 — Connecting the Printer
PF2i and PF4i Mid-Range Printer User’s Manual
55
2
Send one of the following commands to enable WPA-802.1x or
WPA2-802.1x authentication. You should also send the WPA_PSK
command that does not contain a value:
<STX><SI>ws,WPA,OFF<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, <ETX>
3
Send these commands to configure the EAP_TYPE:
<STX><SI>ws,EAP_TYPE,
xxxx
<ETX>
where
xxxx
can be OFF, LEAP, PEAP, TTLS, or EAP-FAST.
<STX><SI>ws,.EAP_USER,
xxxx
<ETX>
<STX><SI>ws,EAP_PASS,
xxxx
<ETX>
where
xxxx
is the unique username and the unique password for
this protocol.
4
If you are using TTLS, you may need to send this command to set
the TTLS outer name:
<STX><SI>ws,TTLS_USER,
xxxx
<ETX>
where
xxxx
is the outer name.
5
If you are using EAP-FAST, you can use PAC and ACQUIRE_PAC
commands. The PAC setting specifies the PAC file to use for EAP-
FAST authentication. The ACQUIRE_PAC setting checks to see if
automatic PAC file provisioning is enabled. You can set
ACQUIRE_PAC to on or off.
•
Send the following command to set PAC to use /tmp/my.pac
with a pass phrase of “verysecret”:
<STX><SI>ws,PAC,/tmp/my.pac@verysecret<ETX>
•
Send the following command to set ACQUIRE_PAC to on:
<STX><SI>ws,ACQUIRE_PAC,ON<ETX>
Summary of Contents for EasyCoder PF2i
