Chapter 2 — Configuring the PB22 and PB32
40
PB22 and PB32 Mobile Label and Receipt Printer User Guide
2
Send one of these commands to enable WPA-802.1x or WPA2-
802.1x authentication. You should also send the WPA_PSK
command that does not contain a value:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, <ETX>
3
Send these commands to configure the EAP_TYPE:
<STX><SI>ws,EAP_TYPE,
xxxx
<ETX>
where
xxxx
can be OFF, LEAP, PEAP, or TTLS.
<STX><SI>ws,.EAP_USER,
xxxx
<ETX>
<STX><SI>ws,.EAP_PASS,
xxxx
<ETX>
where
xxxx
is the unique username and the unique password for
this protocol.
4
If you are using TTLS, you may need to send this command to set
the TTLS outer name:
<STX><SI>ws,TTLS_USER,
xxxx
<ETX>
where
xxxx
is the outer name.
5
If you are using certificates for validation, here are some
commands you may need to use.
•
Send these commands to set a certificate and enable validation:
<STX><SI>ws,CA_CERT,
c:/testCA.pfx
@
export
<ETX>
<STX><SI>ws,VALIDATE,ON<ETX>
where
c:/testCA.pfx
is the location and name of the certificate
and
export
is the passphrase.
•
Send these commands to set a common name for server 1 and
server 2:
<STX><SI>ws, .SERVER_CN1,
xxxxxxxxxx
<ETX>
<STX><SI>ws, .SERVER_CN2,
xxxxxxxxxx
<ETX>
where
xxxxxxxxxx
can be a value from 0 to 64 characters.
Summary of Contents for PB22
