39
16
Troubleshooting the Scanner (continued)
Symptom
Solution
The yellow LED
flashes when you pull
the trigger.
The battery pack power is low. Remove the battery
pack and charge it. For help, see the instruction
sheet that came with the battery pack.
Scanner emits a
continuous beep.
The scanner is out of range of the base. Move the
scanner and base station to within 15 meters (50
feet) of each other.
Scanner does not emit
a beam and does not
operate.
The scanner is not receiving power. Make sure the
battery pack is fully charged. Replace the battery
pack if damaged.
If you continue to encounter problems with your scanner, contact your
local Intermec representative.
Maintaining the Scanner
Water or grime on the window of the scanner will distort the scan beam
and impair performance. Moving from one temperature extreme to
another causes condensation to form on the optical surfaces that affects
scanner performance.
•
Clean the window with a cotton cloth moistened with an ammonia
or water solution. Dry with a soft cotton cloth or allow to air dry.
•
Do
not
use a dry tissue to wipe the window. This causes small
scratches on the window that will gradually affect performance.
•
Do
not
immerse the scanner in water.
•
Operate and store the scanner and battery pack in an environment
with 0% to 95% relative humidity.
•
Operate the battery pack in temperatures within -20°C to 50°C (-4°F
to 122°F) and store the battery pack in temperatures within -30°C to
60°C (-22°F to 140°F).
Summary of Contents for Sabre 1552 Scanner
Page 1: ...Sabre 1552 Bar Code Scanner User s Guide ...
Page 4: ...1233 blank ...