nugget
39
AGaramond
Chapter 1— Learning About the Terminal
Trakker Antares 242X Handheld Terminal User’s Manual
27
3
Press the Scan button on the keypad. Direct the beam so that it falls
across all bars in the bar code label. When the terminal successfully
reads the label, you hear a high beep.
I/O
F1
F2
F4
F3
F5
Fn
L
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
Z
V
W
X
Y
Fn
R
En
ter
7
8
9
4
5
6
1
2
0
3
Ta
b
Es
c
*B02
418*
242XU034.eps
Scanner LEDs
(2 places)
Scan button
TRAKKER
ANT
ARES
2425
4
When the scanner laser beam is on, both scanner light emitting diodes
(LEDs) at the top of the keypad are lit in a yellow color.
After you successfully scan the bar code label, the LEDs are lit in a green
color. The LEDs turn off after 2 seconds unless you start scanning
another label.
5
Release the Scan button.
Note:
You can configure scanning options to scan multiple bar code
labels without pressing the Scan button each time. For help, see
“Scanning Options” on page 28.
*NANCY*
Quiet zone before and
after bar code
242XU076.eps
Quiet zone:
To successfully read a bar code label, the laser beam in the scan module
must see all the bars in a label and a clean, non-printed space, or “quiet zone,” at each
end of the label.
Use the following guidelines to achieve a successful scan:
• Hold the terminal so that the scanner is pointing toward the bar code
label. Tilt the terminal up or down slightly (20 degrees).
Summary of Contents for Trakker Antares 2400
