24
Getting Started
Check to see that all the components shown at left were
included with your
Twinscope.
If a part is missing, contact
your dealer or the
Interphase Customer Service Department
(831) 477-4944
immediately.
WARNING: DO NOT
operate the
Twinscope
with parts
missing or with parts other than those obtained through
Interphase
; doing so could cause a malfunction in the unit. Any
malfunctions to the
Twinscope
resulting from unauthorized
parts are not covered by warranty.
Turning the Twinscope On
To turn the
Twinscope
on, press the Power/ Backlight Key
located on the lower right corner of the unit one time. The unit
should sound a beep and the display should be illuminated.
The Control Center
From the
Contol Center
the
Contrast
can be adjusted by
turning the
Control Knob
cockwise to darken, counter
clockwise to lighten. Seven of the most popular displays have
been pre-programmed into the
Twinscope’s
memory and can be
quickly selected from the
Control Center
Menu. In the
following sections, these different displays are called “
Views”
.
They include:
♦
Full Screen Forward View
♦
Full Screen Track Plot View
♦
Full Screen Chart (Conventional) View
♦
Full Screen Set-Up View
♦
Split Screen Data View with Large Digits on left and
Forward looking display on right.
♦
Split Screen View with Chart (Conventional) display on
left and Forward looking display on right.
♦
Split Screen View with Chart (Conventional) display on
left and Track Plot display on right.
Each of these views can be easily selected by pressing the
button below the desired menu selection. Where two selections
are possible, press the button again until you see your desired
view. When first turned on, the
Twinscope’s
internal memory
automatically sets the starting view to the last one you used
before turning off the power.
The flow chart diagram page 27 shows how to easily navigate
between the
Twinscope’s
Views. The softkey on the left will
select either the Vertical (
Probe
) or the Horizontal (
Sea Scout)
scanning modes.
12 VDC
Power
Cable
Display
Mounting
Bracket
Mounting
Knobs
Thru-Hull Transducer(s)
Transom Mounted Transducers
Display Unit
Summary of Contents for Color Twinscope
