Interroll Diverter SH 1500
Version 1.0 (06/2022) en
Translation of original operating instructions
49
Maintenance and repair
Observe the following for maintenance and repair
DANGER
Danger to life from electrical voltage!
4
Switch off the power supply system, ensure that it cannot be switched on accidentally and
check that there is no voltage.
WARNING
Risk of crushing and injuries
4
Ensure that the personnel involved in maintenance and repair have secure footing and
sufficient room to move.
4
Mechanical maintenance and repair work should be performed only by service personnel.
Observe the safety information.
4
Electrical maintenance and repair work should be performed only by authorized electricians.
Observe the safety information.
4
Observe the weight of the module (see type plate), if necessary, work in pairs.
4
Use suitable loading and lifting equipment. Secure the module against falling or tipping.
CAUTION
Risk of injury due to improper handling or accidental motor starts
4
Maintenance work and cleaning must only be performed by qualified and authorized
persons.
4
Perform maintenance work only after switching off the power. Ensure that the conveyor
cannot be switched on accidentally.
4
Set up signs indicating that maintenance work is in progress.
When tightening screws and nuts, always observe the standard tightening torque, unless
specifically indicated otherwise. Standard thread lockers must be replaced as needed.
Torx screws and nuts used in elongated holes must have a washer so that they can be loosened
again if necessary (e.g., for disassembly).
4
Work on electrical equipment must only be performed by authorized electricians.
4
Set up warning signs that indicate maintenance and repair work.
4
Block off the area around the module.
4
Inform persons who must enter the blocked-off area about the risks.
