Interroll Diverter SH 1500
Maintenance and repair
Version 1.0 (06/2022) en
Translation of original operating instructions
59
Replace the sprockets
To replace the sprockets, it is first necessary to remove the drum motor.
When replacing the sprockets, the set collars must also be replaced.
4
3
4
2
3
2
1
1
Setscrew
3
Sprocket
2
Drum motor
4
Set collar
CAUTION
Risk of injury when lifting heavy loads
4
Use a tool or a second person for steps directly involving the motor.
Fasten screws with a tightening torque of 3.5 Nm.
Requirement:
R
The module is shut down.
4
Remove the ball module conveyor,
see "Replacing the ball module conveyor", page 56
.
4
Remove the drum motor,
see "Replacing the drum motor", page 57
.
4
Pull the sprockets (3) off the drum motor (2) by and by.
4
Loosen setscrews (1) from the set collars (4) to be able to replace the two middle
sprockets (3).
4
Pull set collars (4) off the drum motor (2).
4
Properly dispose of the old sprockets and set collars.
4
Push new set collars (4) onto the drum motor (2) to position the two middle sprockets (3),
fasten set collars (4) with setscrews (1).
4
Push new sprockets (3) onto the drum motor (2) by and by.
4
Reinstall drum motor and ball module conveyor in reverse order.
