Interroll Module belt conveyor SH 1100
Maintenance and repair
52
Version 1.0 (06/2022) en
Translation of original operating instructions
Removing/installing cover
plates at return axles
7
4
6
3
5
2
1
Head drive view
1
Side frame
5
Cover plate
2
Return axle
6
Washer (small)
3
Torx screw
7
Nut
4
Washer
Fasten screws with a tightening torque of 19 Nm.
Requirement:
R
The module is shut down.
4
Loosen screws (3) from the side frame (1) and remove cover plate (5).
4
After the maintenance work: Install cover plate (5) from below at the return axles (2).
4
To do so, guide two screws each (3) on the right and left with two washers (4) from the inside
through the C-profile and fasten it from the outside with two small washers (6) and
two nuts (7).