8.
Assemble the hose clamp.
Tighten the hose clamp until the cover is locked but still possible to turn
without the anti freezing cap turning together with it.
Winding the supply hose
To avoid kinking of the supply hose it is important to wind the hose in such way
that it is free from twisting (kinks). Kinks can result in flow restrictions. The
supply hose should be wound up pressurized in a figures of eight with a
diameter greater than 500 mm (1.5 feet) for each turn. Alternatively, the hose
can be wound in a ring, but then it must be turned in the upper and lower turns
when it is wound.
When the supply hose has been wound and the pressure in the hose has been
released, it should be secured to hold it in place during handling and transport.
The ends of the supply hose must always be protected from water and dirt by
connecting the ends of the supply hose to the supplied vent handle.
DP1
22
