10
CYLINDER PACK
Mounting
1.
Place the cylinder pack on a flat surface with the cylinder valve towards you.
2.
Check the connection O-ring and screw the cylinder valve hand-tight to the
cylinder connection of the manifold block. [Fig. 7]
NOTE!
FOR CYLINDER QUICK COUPLING SEE SECTION CYLINDER QUICK COUPLING OPTION.
3.
Fit the holes of the cylinder bracket onto the guide washers and push the
backplate away from you until the harness clicks in position [Fig. 8]. Check that
the cylinder pack is mounted properly by lifting the harness carefully in the upper
and lower part of the backplate.
Dismounting
1.
Unscrew the cylinder connection of the manifold block from the cylinder valve.
2.
Push the locking arm on the upper part of cylinder bracket and pull the harness
towards you at the same time.
QUICK COUPLING OPTION
Connection
Connect the cylinder valve adapter with the cylinder connection manifold. Press
together until the manifold “clicks” into the cylinder valve [Fig. 10].
Check that the connection is properly locked by checking that the surfaces are in line
with each other [Fig. 10].
Disconnection
Disconnect by pressing the ring of the quick coupling away from the cylinder valve and
removing the manifold [Fig. 11].
NOTE!
EXISTING EQUIPMENT CAN BE UPGRADED TO CYLINDER QUICK COUPLING.
3 INSTALLING / REMOVING HUD
INSTALLING THE WIRELESS HUD
1.
Place one side of the HUD on an angle inside the mask and press down.
2.
Make sure the right and left side of the HUD are securely seated in the rounded
areas of the mask rubber, and below the two protruding lugs on the visor.
REMOVING THE WIRELESS HUD
1.
Lift one end of the HUD and remove it from the mask.
Summary of Contents for INCURVE-E
