Weight
•
Insert interspiro’s system weights in the pockets you want to use. Each
system weight is 0,5kg.
The droppable pockets can fit six system weights and the weight pockets
can fit four system weights.
Make sure that the weights are distributed evenly on the BCD to achieve a
good balance in the water.
Ballistic plates
•
Open the molle and velcro closure on the ballistic weight pockets and slide
in your ballistic plate. Lock the velcro and guide through the molle bands to
further lock the closure.
Regular inspection
1.
Visually inspect the BCD material and fittings for signs of damage or
excessive wear.
2.
Operate the quick release connector on the medium pressure hose. Make
sure that the connector operates smoothly. Connect the quick release
connector to the power inflator.
3.
Inflate the BCD until the over pressure valves start to vent. Check that
the speed of the inflation rate is satisfactory. Check for leaks, especially
around the valves (once they have finished venting the excess pressure).
4.
Operate all the dump valves, including the inflator dump and elbow dump
on the convoluted inflation hose. Make sure that the valves opens and
closes properly.
5.
Inflate again until the over pressure valves start venting and leave the BCD
for an hour to see that it is still “firm” in its inflation grade after that time.
Don’t leave it out in the sunshine.
Important: if you find any damage or problems, do not use the BCD, contact
your service organization or interspiro for advice. Unauthorized repairs or
modifications may be dangerous and could affect the functionality.
Donning
Donning the OX10 molle bc
1.
Open the cylinder valve on the inflation cylinder.
OX10 MOLLE BC
24