background image

SAVE THESE INSTRUCTIONS 

LIMITED WARRANTY 

InterVac Design Corp. will repair the power unit with new or rebuilt parts, free of charge for two (2) years 

in North America from the date of original purchase in the event of a defect in materials or workmanship.  

Warranty might vary from country to country.  No cash refunds.  Excluded are the following items that 

require normal replacement: 

Disposable dust bags, filters, vacuum cleaner tools, and vacuum hoses.  

This warranty is extended only to the original purchaser.  A purchase receipt or other proof of date of 

original purchase will be required before warranty performance is rendered. 

You must return your warranty card or register on our website in order to be covered under these 

provisions.  

This warranty only covers failures due to defects in materials or workmanship which occurs during normal 

use and does not cover damage which occurs in shipment or failures which are caused by products not 

supplied by InterVac Design, or failures which result from accident, misuse, abuse, neglect, mishandling, 

misapplication, alteration, modification, or commercial use such as hotel, office, restaurant or rental use of 

the product, or service by anyone other than an authorized service center, or damage that is attributable 

to acts of God.  There are no expressed warranties except as listed above. 

LIMITS AND EXCLUSIONS: 

INTERVAC DESIGN SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES 

RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF THIS 

WARRANTY.  ALL EXPRESSED AND IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF 

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO THE 

APPLICABLE WARRANTY PERIOD SET FORTH ABOVE. 

Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations 

on how long an implied warranty lasts. The above exclusions or limitations may not apply to you.  This 

warranty gives you specific legal rights that vary from state to state.  If a problem with this product 

develops during or after the warranty period, you may contact your dealer or our service center.  If the 

problem is not handled to your satisfaction, then write to the Customer Service Center at the company 

address. 

MODEL GH-120                                                                                 MODEL GH-220 

120 Volt, 10 Amp 50/60 Hz, 530 Air watts, Wt. 9 lbs         220 Volt, 5 Amp 50/60 Hz,530 Air watts, Wt. 4kg 

 

                                                 

USES REPLACEMENT DUST BAGS Y08-5 

For Installing on Drywall, Wood or Block Wall: 

1.  Choose a wall or surface that has an electrical outlet close by. Tape the enclosed template to the 

wall or other surface, a minimum of 3” above the floor to allow for exhausting air. 

For drywall 

installation

:  Align the template so that the two vertical center point of the template are aligned 

over the centerline of a 2 x 4 stud behind the drywall for additional stability. 

For wood

: Use all 

four #8 screws and attach directly to wall.  

For Concrete

:  Use concrete anchors.  Use a level for 

alignment. 

2.  With an awl or similar pointed object mark the center of the key holes accurately.  Carefully 

remove template from the wall and place with the manual for future reference. 

3.  Using a 3/32 drill bit, pre-drill all four holes. 

4.  Use a 5/16 drill bit to enlarge

 only 

the two holes which go through the drywall without stud 

support.  These are the holes that require two drywall anchors. 

5.  Squeeze the two arms of the plastic anchor together and insert through the hole.  Tap the anchor 

with a hammer to push it flush with the drywall surface.  Insert the red key-pin and push firmly to 

toggle the anchor open behind the drywall.  Remove the red pin. 

6.  Attach all four #8 screws through the marked keyholes.  Keep the screw heads 1/8” from the wall 

surface. 

7.  Attach the tool caddy to the GarageVac by sliding the “dove tails” on the bottom of the caddy into 

the grooves on top of the unit.  Install the GarageVac with the tool caddy onto the screw heads by 

aligning the keyholes on the back of the unit with the screw heads on the wall and push down on 

Summary of Contents for garage vac GH-120












Reviews: