INSTALLATION
22
12
11
10
Upon successful completion of the above, the
following confirmation message should appear:
ALL GOOD
- this indicates your selections have
been sent to the device and accepted. It does not
confirm the integrity of your wiring installation.
In the event a
SYS
message error is displayed,
disconnect, then reconnect the main battery
positive cable and re-commence step
7
. If the
error persists re-check the Data Cable connection.
If this does not resolve the problem, please refer
to the troubleshooting information on page 34.
Configure the Charging Device: Confirming configuration
The next step is to confirm the ignition control
setting. Use the and buttons to select one
of the two following options:
I.
Select
NORMAL
for conventional
(non ECU) charging systems.
II.
Select
LOW
for ECU controlled
electrical systems.
III.
Press the
button to confirm and
continue to next step.
OK
Configure the Charging Device: Ignition control setting
OK
Following the last step (
9
) confirm if you
want to enable ignition control mode.
Use the and scroll buttons to select
one of the two following options:
I.
To disable ignition mode select
OFF
II.
To enable ignition mode select
O
n
III.
Press the button to confirm and
continue to next step.
Configure the Charging Device: Ignition control mode
