19
Position controlled blind
This type of device corresponds to the position controlled blinds.
The group addresses to configure are:
-
Stop-movement 1bit:
it allows to lift up/down the blind slightly (in some
blind actuators), or in case it is moving, stop it.
-
Up-down 1bit:
it allows lifting up/down the blind continually, or in case it is
moving, stopping it. This communication object is activated with a long tap
to the button (more than 0.5 seconds).
-
Position 1Byte:
1Byte control communication object for the 8 bits control.
-
Position status 1Byte:
position status feedback.
For the correct functioning of the device, it is important to check if the position status
1Byte reading flag has been enabled in ETS.
Summary of Contents for Houseinhand
Page 1: ...Configuration manual v2 5...
