IntesisBox
®
KNX
– Mitsubishi Electric A.C.
User's manual r2.3 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
info@intesisbox.com
+34 938047134
9 / 63
4. ETS Parameters
When imported to the ETS software for the first time, the gateway shows the following
default parameter configuration:
Figure 4.1
Default parameter configuration
With
this configuration it’s possible to send On/Off
(
Control_ On/Off
), change the AC Mode
(
Control_ Mode
), the Fan Speed (
Control_ Fan Speed
) and also the Setpoint Temperature
(
Control_ Setpoint Temperature
). The Status_ objects, for the mentioned Control_ objects,
are also available to use if needed. Also objects
Status_ AC Return Temp
and
Status_
Error/Alarm
are shown.
Figure 4.2
Default communication objects