5
WARNING: To reduce the risk of injury, user must read and understand operator’s manual.
General safety rules
CHARGING A HOT BATTERY PACK
If the battery pack is above normal temperature range, the red LED will be lit and the green LED will be off. When the battery pack
cools down to approximately 104°F (40°C), the Charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
If the battery pack is below the normal temperature range, the red LED will be lit and the green LED will be off. When the battery
warms to a temperature of more than 32°F (0°C), the Charger will automatically begin charging.
DEFECTIVE BATTERY
If the Charger detects a problem, the red LED will begin flashing and the green LED will be off.
• If defective, remove and reinsert the battery pack in the Charger. If the LED status reads “defective” a second time, try charging
a different Lithium-Ion battery pack.
• If a different Lithium-Ion battery pack charges normally, dispose of the defective battery pack (see Maintenance section).
• If a different Lithium-Ion battery pack also indicates “defective,” the Charger may be defective.
BATTERY CHARGING
If the battery pack is within normal temperature range, the green LED will begin flashing and the red LED will be off. The Lithium-
Ion battery pack will reach a full charge. The POWER BAR LED lights will cycle right to left during charging. This is part of the
normal charging operation. The POWER BAR LED lights will not be displayed when the POWER BAR button is pressed while the
battery pack is on the Charger.
BATTERY FULL
If the battery pack is within normal temperature range, the green LED will be lit and the red LED will be off. The Lithium-Ion
battery pack is fully charged and ready to use. The battery pack will fully charge, but will not overcharge, if left on the Charger.
The POWER BAR LED lights will not be displayed when the POWER BAR button is pressed while the battery pack is on the
Charger.
NOTE: Charger may warm up with several continuous charge cycles.
This is part of the normal operation of the Charger. Charge in a well ventilated area.
WALL-MOUNT CAPABLE
The Charger has a key-hole hanging feature for
convenient storage. Screws should be installed
so that the center distance is 4 1/8-in. Use
appropriate wall fasteners to accommodate the
combined weight of the Charger and battery
pack. (approximately 3.5 lbs.)
CORD WRAP
The Charger is equipped with a cord wrap
on the rear of the unit. Utilize this feature to
minimize workspace clutter and hazards.