MAINTENANCE (continued)
INTEX
®
COPPER ION TEST STRIPS (PACKED WITH THE PRODUCT)
The Copper Ion Test Strips can be used to test the copper ion concentration in the
water.
Directions and Use
1
. Dip the entire strip into the water for 3 seconds, then remove it
2
. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3
. Now compare the copper ion strip pad to the color chart on the packaging
label.
INTEX
®
3-WAY TEST STRIPS (PACKED WITH THE PRODUCT)
The 3-Way Test Strips can test the “Free Chlorine”, “pH”, and “Total Alkalinity” lev-
els at the same time.
The water parameters must be maintained as part of daily
maintenance, and the chlorine concentration must be maintained between 0.6-3 ppm.
Directions and Use
1
. Dip the entire strip into the water and remove immediately.
2
. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3
. Now compare the strip pad to the color chart on the packaging label. If
necessary, adjust the chemical level in the pool water. It is very important, to
use the proper technique when testing the water's chemical level. Read and
follow the written strip instructions carefully.
LONG TERM STORAGE
1
. Disconnect the power cord from the electrical outlet.
2
. After the pool is completely empty, disconnect the Saltwater System from the
hoses by reversing the installation instructions.
3
. Air-dry the unit before you store it. This might be a good time to visually inspect
and clean the electrolytic cell.
4
. Store the unit and accessories in a dry place. The temperature should be
controlled, between
0 degrees Celsius
(
32 degrees Fahrenheit
) and
36 degrees Celsius
(
97 degrees Fahrenheit
).
5
. The original package can be used for storage.
SAVE THESE INSTRUCTIONS
Page 28