299
A
S AVE THESE INSTRUCTIONS
(299IO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 05/30/2018
English
Page 17
LED CODE CHART
1) Always keep the spa cover on to minimize heat loss during heating of the spa between
uses (but not while it is being used). Ensure the cover is fi tted tightly, as per manufacturer’s
instructions to maximize insulation. It shall be recommended that the cover, when not in
use, should be kept off the ground to retain its cleanliness (particularly the surface in close
proximity to the water spa water surface). The cover should be stored in an appropriate
location, where it cannot be damaged, or cause damage.
2) Check the set water temperature and consider lowering it for the times when the spa will
typically not be in use.
3) Depending on external conditions, consider turning off the heater entirely if not using the spa
for an extended period of time (where the spa provides this option, but still maintains residual
disinfection/pH-values).
4) Consider that the comfortable temperature range during use may be lower than the maximum
safe temperature.
5) Use the included insulating ground cloth underneath the spa to minimize heat loss through
the bottom of the spa.
6) Maintain
clean
fi lters to preserve appropriate working conditions for the pump and avoid
unnecessary water replacement and re-heating.
MINIMIZE HEAT LOSS AND ENERGY CONSUMPTION ADVICE
LED Reading
Defi nitions
001H
Operating Hour (1 hour remaining)
002H
Operating Hours (2 hours remaining)
003H
Operating Hours (3 hours remaining)
004H
Operating Hours (4 hours remaining)
005H
Operating Hours (5 hours remaining)
006H
Operating Hours (6 hours remaining)
007H
Operating Hours (7 hours remaining)
008H
Operating Hours (8 hours remaining)
E90
No water fl ow
E91
Alarm Code (Low Salt Level)
E92
Alarm Code (High Salt Level)
E94
Water temperature too low
E95
Water temperature is around 50°C (122°F)
E96
System Error
E97
Dry-fi re Protection
E99
Water temperature sensor broken
END
After 72 hours of continuous heating operation, the pump will hibernate
automatically. The rapid heating and water fi ltration functions are
disabled.
