275
PO
S AVE THESE INSTRUCTIONS
(275PO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 06/23/2015
English
Page 19
MAINTENANCE (continued)
1.
Drain and clean the spa following the “Spa Tub Drainage” and “Spa Tub Cleaning” sections.
2.
Reverse set up instructions to de
fl
ate and disassemble the spa tub, spa control unit and spa cover air
bladder.
3.
Spa Tub de
fl
ation with the Electric Air Pump
(see drawing 17)
.
a) Attach the in
fl
ation pump adaptor
(24)
to the de
fl
ation port.
b) Connect the in
fl
ation hose
(7)
to the in
fl
ation pump adaptor.
c) Insert the other end of the in
fl
ation hose
(7)
into the valve and turn to
the right to lock it in position. Switch on the electric air pump to de
fl
ate.
4.
Make sure all the spa components and accessories are thoroughly clean
and dry before storage. Air-dry the spa tub in the sun for an hour before
folding.
5.
Fold the spa tub loosely and avoid any sharp corners to prevent damage
or leakage to the spa tub liner.
6.
Prepare additional new cartridges for next time use.
7.
Store the spa tub and accessories in a dry, temperature controlled,
between 32º – 104 ºF (0º – 40ºC), storage location.
8.
The original packing can be used for storage.
STORAGE
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
•
Clean and dry the area to be repaired thoroughly.
•
Remove the patch backing paper and press patch
fi
rmly over the puncture.
Smooth out the surface to remove any air bubbles under the patch.
IMPORTANT
The ambient temperatures of air have an effect on the spa tub internal pressure. Air inside of the
spa tub may expand and contract with varying temperature leading to reduce pressure inside
of the spa tub. If this occurs, simply use the provided pressure gauge to check the internal air
pressure and add more air if necessary.
17
28
7
24
