192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Page 10
SET UP
(continued)
Spa Control Unit Installation
1.
Press the button located on top of the control base
and remove the back cover
(see drawing 9)
2.
Connect the spa control unit to the spa tub
(see drawing 10)
. Hand-tighten the connectors securely.
Do not use tools to tighten.
3.
Reinstall the back cover
(2)
to the spa control base
(see drawing 11).
Back cover must be installed
before using the SPA.
CAUTION:
Do not sit, lean, cover or place any objects over the spa control unit.
4.
Attach the two filter cartridge housing assemblies to the two outlet
grids on the inside of the spa (lower position, marked “C”).
ATTENTION!
In order to comply with the requirements of the
Virginia Grahame Baker Act, suction outlets cannot be covered
while the spa is in use. The Act was intended to address high
suction / volume circulation systems but does not exclude low
volume systems as used on this spa. Accordingly, remove the filter
cartridge assemblies and any other spa cleaning attachment from
the spa outlets before spa usage
(see drawing 12)
.
Re-attach them after usage for water filtration and cleaning.
5.
Before filling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
6.
Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over fill the spa.
.
WARNING:
Never pour water with a temperature higher than 104°F (40°C) into the spa directly. It is
recommended to fill the spa tub with lukewarm water for quick heating and energy saving.
7.
Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT:
Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
8.
Turn on the heater on the spa control unit see “Spa Control Unit Panel” operating instructions section.
The heating system is capable of increasing the water temperature by approximately 2-3ºF (1-1.5ºC)
per hour.
11
2
10
A
B
C
B
C
A
9
Press
A
B
C
B
C
A
12
C
