192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Page 12
LED CODE CHART
E90
No water flow
•
Ensure the unit is plugged and switch on.
•
Ensure the outlet cover grid is clean and free
from obstructions.
•
Clean or replace the cartridge, see Maintenance
and Storage section.
•
Ensure the in/outlet connections on the spa tub
and filter pump are not blocked.
•
If problem persists, contact Intex Service
Center.
E94
Water temperature too low
•
If the ambient temperature is below 39°F (4°C),
we recommend not to use the spa.
•
Press the temperature increase button to set
the desired water temperature.
•
If problem persists, contact Intex Service
Center.
E95
Water temperature too high
•
Press the temperature decrease button to
lower the water temperature.
•
When the water has cooled down to 104°F
(40°C), press the RESET button.
•
If problem persists, contact Intex Service
Center.
E96
System Error
•
Unplug and plug the GFCI/RCD.
•
If problem persists, contact Intex Service
Center.
END
After 72 hours of operation,
the pump will hibernate and
the rapid heating and water
filtration functions are disabled.
•
Press the water filter button to re-active the
filter pump.
LED Reading CAUSE SOLUTION
