192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Spa Tub Drainage
1.
Turn off all the buttons (heater, filter and bubble) on the control panel unit.
2.
Connect the drain valve adaptor to a garden hose and point the other end
of the garden hose to a suitable draining area
(see drawing 14).
3.
Remove the drain valve cap from outside of the spa tub and attach the
drain valve adaptor to the drain valve
(see drawing 14).
4.
From inside of the spa tub, open the drain valve cap, water will start
flowing out from the garden hose.
5.
When the water stops draining, disconnect the spa control unit from
the spa tub wall. Lift the spa tub wall from the side opposite the drain,
leading any remaining water to the drain and emptying the spa completely
(see drawing 15).
6.
Raise up the spa control unit and open the cap underneath the filter
pump unit, drain out the water
(see drawing 16). Do not tighten the cap
now.
7.
Attached the inflation hose
(7)
to the air blower inflation outlet on top
of the control panel section.
8.
Press the button, aim the inflation hose at the inlet/outlets on the spa
tub and spa control unit to dry out any water in the piping system.
(see drawings 17 & 18).
9.
When the water stops draining, raise up the spa control unit again and
tighten the cap underneath the filter pump unit back
(see drawing 19).
10.
Use a clean towel to wipe up any remaining water and moisture on the
spa tub and spa control unit.
11.
Ensure the spa tub and spa contol unit are thoroughly dried.
NOTE:
The enclosed plugs
(15)
can be used to cover the water inlet and
outlet connectors from the inside of the spa tub to prevent water from
flowing out.
Spa Tub Cleaning
If dirt is visible in the water or water becomes cloudy and proper water
chemistry does not clear it up, change the water and clean the spa tub.
See “Spa Tub Drainage” section on how to drain the spa.
While empty, remove the cartridge housing from inside of the spa tub wall,
clean and/or replace the filter cartridge. Use a sponge and mild soap solution
to wipe away any soil or stains on the inside of the spa wall. Rinse thoroughly
before refilling with clean water.
IMPORTANT:
Do not use steel wool, hard brushes or abrasive cleaners.
Spa Tub Air Valve Fastening
Check the spa tub air valve for leakage and tightness before use. If air is leaking
from the air valve, use the provided wrench
(22)
to tighten the air valve as follow:
1.
Make sure the spa tub is deflated, open the air valve cap and insert the
wrench
(22)
into the air valve body
(see drawing 20).
2.
With one hand, hold the backside of the air valve base from the inside of
the spa tub wall and turn the wrench
(22)
clockwise.
IMPORTANT:
Do not over tighten the air valve. Never adjust the air
valve base when the spa is in use or filled with water.
Spa Cover
Inspect the spa cover regularly for leaks, premature wear and tear, damage,
or signs of deterioration. Never use a worn or damaged cover: it will not
provide the level of protection required to prevent unsupervised access to the
spa by a child.
MAINTENANCE
Page 14
14
17
16
19
18
˚
C
˚
F
RESET
104
F
o
1
2
3
20
11
22
7
7
15
