192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Page 9
SET UP
(continued)
4.
Press the button to inflate the spa tub wall until it is firm to the touch but not hard
(see drawing 5)
.
IMPORTANT:
Do not over inflate or use high pressure air compressor to inflate.
5.
Press the button again to turn it off.
6.
Disconnect the inflation hose
(7)
from the air valve and attach the pressure gauge
(23)
to the air valve.
The pressure gauge indicator should be in the green area for a properly inflated spa tub
(see
drawing 6)
. Repeat previous steps to add more air if necessary.
7.
Replace the air valve cap back.
NOTE:
The cap is designed to be screwed on and off. Never exert force as this could cause the
complete internal inflation system of the valve to come loose. See “Spa Tub Air Valve Fastening” for
valve maintenance.
Inflate the Spa Cover Air Bladder
1.
Open the inflation valve and insert the inflation
hose
(7)
into the valve; press to inflate
until it is firm to the touch but not hard
(see
drawing 7).
2.
Disconnect the inflation hose
(7)
from the air
blower inflation outlet and the valve.
3.
Replace the control panel cap
(5)
back; close and
recess the inflation valve.
NOTE:
If there is a need to add some air to the spa tub
wall or spa cover air bladder after they have been setup,
refer to above “Inflate the Spa Tub Wall” and “Inflate the
Spa Cover Air Bladder” sections.
Deflation
For
Spa Tub Wall:
1.
Unscrew the cap to reveal the stem, push the stem
in and turn 90 degree right to secure it in the down
position
(see drawing 8).
2.
Once the deflation is completed, push the stem in
and turn 90 degree left to return it to the inflation
position.
3.
Replace the cap back.
For Cover Air Bladder:
1.
Pull valve cap out and squeeze the valve at its base
until deflated.
2.
Close and recess the valve back.
8
˚
C
˚
F
RESET
104
F
o
˚
C
˚
F
RESET
104
F
o
˚
C
˚
F
RESET
104
F
o
7
7
5
6
0.01
0.02
0.03
0
1
2
3
4
5
0
psi
MPa
23
˚
C
˚
F
RESET
104
F
o
