(285PO) LED POOL SPRAYER ENGLISH SIZE: 4.875” X 7.25” 04/19/2020
English
285
PO
SAVE THESE INSTRUCTIONS
Page 3
FIG (3)
Maintenance and Long Term Storage
1.
Regularly check all components for sign of damage, straining. Discard and replace
damaged components immediately.
2.
Use a sponge and clean water to wipe away any soil or stains.
3.
Disassemble the product when the temperature drops below 5
o
C (41
o
F) by reversing
the above setup instructions, drain the water out of the sprayer, and make sure all
components are completely dry before storage.
4.
Store the sprayer and accessories in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
5.
The original packing can be used for storage.
3. For filter pump with 32mm hose (1.25 in):
a) Turn off / unplug the filter pump, cover the inlet fitting from inside of the pool to prevent
water from flowing out, disconnect the pump return hose (from pump to pool) from the
pool inlet fitting.
b) Attach adaptor A
(4)
to the sprayer inlet, then connect the pump return hose to the
adaptor A. See fig 3. Turn on / plug the filter pump.
4
TROUBLE
SOLUTION
LED light is off /
flashing
• Ensure the filter pump is operating and connect the LED
pool sprayer to the water return hose, see “Setup” section.
• Check if the pump system flow rate is within the specified
range, if the system flow rate is less than 2,271 L/h
(600 gph), change pump with higher system flow rate.
• Clean or replace the filter pump cartridge. If using a sand
filter, ensure the sand media is clean by backwashing it.
• Use a garden hose to wash the sprayer head opening,
check to see if any sand or deposits in the sprayer head set.
• Contact Intex Service Center.
Poor water cascade
performance
• Use fingers to wipe away any dirt on the sprayer head
opening.
• The performance depends on the filter pump flow rate.
If you are not satisfied with the water cascade performance,
a higher flow rate filter pump is recommended.
Water spraying out of
the pool
• The performance depends on the filter pump flow rate,
change pump with lower system flow rate.