348
PO
S AVE THESE INSTRUCTIONS
(348PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/25/2019
English
Page 12
SET UP (continued)
Spa Control Unit Installation
1.
Connect the spa control unit to the spa tub
(see drawing 9)
. Hand-tighten the connectors securely.
Do not use tools to tighten.
NOTE:
Never attach external accessories not supplied with the kit to the spa tub or control base unit, as
this will void the warranty.
2.
Replace the control base side covers
(4)
(see drawing 10)
.
CAUTION:
Do not sit, lean, cover or place any objects over the spa control unit.
3.
Attach the two filter cartridge housing assemblies to the two outlet
grids on the inside of the spa (lower position). Inflate the spa tub
first before installing filter pump fittings.
ATTENTION!
In order to comply with the requirements of the
Virginia Grahame Baker Act, suction outlets cannot be covered
while the spa is in use. The Act was intended to address high
suction/volume circulation systems but does not exclude low
volume systems as used on this spa. Accordingly, remove the filter
cartridge assemblies and any other spa cleaning attachment from
the spa outlets before spa usage
(see drawing 11)
.
Re-attach them after usage for water filtration and cleaning.
4.
Before filling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
5.
Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over fill the spa.
Never move the spa tub with water inside and/or with the control base attached to the spa as the spa or
control base may be damaged.
WARNING:
Never pour water with a temperature higher than 104°F (40°C) into the spa directly. It is
recommended to fill the spa tub with lukewarm water for quick heating and energy saving.
6.
Place the spa cover and spa air bladder (pre-installed in spa cover)
over the spa tub, and make sure the spa cover buckles are locked using the key provided after pulling the
buckled straps tight.
IMPORTANT:
Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
7.
Ensure that the spa base is plugged into a properly located and sized electrical outlet and press the
button to turn on the control panel. Press the
button on the control panel to activate the heater, see “Spa
Control Panel” operation section.
10
9
11
