348
PO
S AVE THESE INSTRUCTIONS
(348PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/25/2019
English
Page 7
PRODUCT SPECIFICATIONS
SET UP
Maximum seating capacity:
4 adults
Water capacity:
210 gal (795 L)
Inner/outer diameter:
57/77 in (145/196 cm)
Height:
26 in (66 cm)
Bubble air blower:
800 Watts
Filter pump flow rate:
460 gal/hr (1,741 L/hr)
Heater power:
1,300 Watts / 110-120 V / 60 Hz
Temperature range:
68ºF – 104ºF (20ºC – 40ºC)
Temperature rise:
2-3ºF/hr (1-1.5ºC/hr)
Number of Bubble Jets:
100
Cord-connected spa with pump, heater, blower and control panel.
Note:
the spa equipment features a complete grounding system that is also in contact with the spa water.
It is possible that a person may build up static electricity that discharges when touching the water.
Regardless, any electric shock experienced should be investigated by a qualified electrician prior to use of
the spa. Unplug the spa until the cause is determined and any corrective action completed.
Site preparation and requirements
• The spa can be installed indoor or outdoor. For household use only.
• The spa must be setup on a level, flat and smooth surface that is capable of supporting the maximum
load of the filled spa with four adult occupants: weight 2500 lbs (1136 kg).
• Make sure the area is free of sharp objects under or around the spa.
• Provide adequate drainage system around the spa to deal with overflow water and splashes.
• Provide a properly located power outlet to connect the spa and allow easy access for periodic testing of
the cord mounted GFCI/RCD.
• Make sure there is enough clearance around the spa for full access to the spa equipment for
maintenance and/or service.
• The area shall facilitate draining purposes during long term spa storage.
Additional requirements for indoor installation
• Make sure the floor can support the full weight of the filled spa with the maximum number of occupants.
Check with a qualified contractor or a structural engineer to verify this requirement.
• Make sure the floor is water resistant and non-slip surface. Do not install the spa on carpet or other
materials that will be damaged by moisture, condensation.
• Do not install the spa indoors on a second floor above finished living space due to the possibility of water
and humidity damage.
WARNING
Risk of fire: This product draws a minimum of 13 AMPS. Most household circuits are 15 to
20 AMPS. If the circuit breaker trips, please check that no other appliances or other large
loads are on the same circuit as the spa. Never use an extension cord. Unfold the line cord
prior to use. Never place the plug on combustible materials.
