When moving the Slide Positioning Model to the needed position,
please push its head there, and fixed the screws manually, then the
model is fixed there, in case the creasing position is not exact.
·
When the Slide Positioning Model is fixed in the need position, put down the
creasing papers from Mechanism core protection cover and rely it on the fixed
Slide Positioning Model back side.
·
If only one piece of perforating is needed, move the paper rightward, and rely it on
the fixed right-side Slide Positioning Model right side. Treat the foot pedal , wait
until the machine stops and take out of perforating paper.Perforating is ready.
·
If two piece of perforating is needed, move the paper rightward first, and rely it on
the fixed right-side Slide Positioning Model right side. Treat the foot pedal , wait
until the machine stops and then move the paper leftward, rely it on the left-side
Slide Positioning Model left side. Treat the foot pedal again, wait until the
machine stops and take out of perforating paper. Perforating is ready.
7. Troubleshooting
If the following glitches appeared during your operation, please
stay calm and follow the following instructions to fix the
glitches. If the glitches remain or other glitches appear,
please find a professional maintenance person.
Insert the blade system into the machine through the Blade Installation Slot.
Open the machine and test with a piece of paper. If the creasing/perforating
effect is not perfect, please follow the steps below to adjust the machine:
7.1 The creasing/perforating is too shallow/deep:
Take the die out off the machine, loose the press adjusting lock screw, if the
effect is too shallow, screw the adjusting screw counter-clock wise, then
tighten the press adjusting lock screw.
If the effect is too deep, screw the adjusting screw clock wise, then tighten
the press adjusting lock screw. After the adjustment, insert the die into the
machine and test again, if the effect is still unsatisfied, just repeat the step
above, until the effect is satisfied.
7.2 The creasing/perforating is not balanced:
Take the die out off the machine, loose the press adjusting lock screw on the
side which is shallow, screw the adjusting screw counter-clock wise, then
tighten the press adjusting lock screw. After the adjustment, insert the die into
the machine and test again, if the effect is still unsatisfied, just repeat the step
above, until the effect is satisfied.
Caution:
Every time of the adjustment to the screw CANNOT be over 90
degrees to avoid the machine locking.
intimus CR-460 ECP
9
9
