7.3 After the creasing/perforating, the dotted line break the paper:
Take the perforating blade system out. Loosen the pressure adjusting locknut
on the shallower side of the dotted line. Rotate the pressure adjusting screw
clockwise. Screw the pressure adjusting locknut tight and put the perforating
blade system back into the machine again and test the perforating. If the
perforating effect is not reaching your need, please repeat the steps above,
until the perforating effect is satisfied.
7.4 The perforating is too shallow/unbalanced:
Repeat the steps above. If not effect, please replace a new blade system.
Caution:
The blade system is daily using consumable. After 10000
times of perforating 5000 times of creasing, the blade
system is suggested to be replaced. That will ensure
the best effect of the machine.
8. Maintenance Notes
·
If the next operation will be operated after a long time, please shut down the
machine to save power and make the machine be long time serviceable.
·
After every operation finished and shut down the machine, please clean the
surface of the machine up. Especially clean the operation panel up to avoid
any granule inside the machine, which may cause any damage to the
machine.
·
Drop some lubricating oil onto the two mandrils and axletree connecting
position to ensure the smooth running of the mechanism every week.
9. Technical Parameter
Function/Model
CR
-460
ECP
Max Working Width
460mm
Max Working Thickness
0.09-0.65mm(Creasing)/0.5mm(Perforating)
Working Speed
1800 times/hour
Working Noise
50-55Db(A)
Power Supply
AC220V/50Hz
Power
150W
Machine Size
Machine Weight
70X53.5X24cm
40kgs