INDUSTRIAL SHREDDER
Instruction manual for use and maintenance
MSM0005EN_
F
67 / 90
6.2
STARTING SEQUENCE
The shredder start is manual-operated. Proceed as follows:
•
Turn the MAIN SWITCH to position 1: the white signal lamp MAINS will light up.
•
Push the RESET button: the yellow signal lamp will start blinking, thus signalling that the
machine is ready to operate, and therefore the maximum attention must be paid.
•
Turn the selector switch FORWARD/REVERSE RUN 1-2 onto position 1 and release it: the
machine will start the “forward running” and the green signal lamp will light up.
•
Keep the shredder in no-load running for 30÷40 seconds only.
•
Feed the material into the feeding hopper.
IMPORTANT NOTICE
Do not let the blade-holding shafts run without material, to prevent them from
overheating and the blades from possibly seizing.
IMPORTANT NOTICE
Should it be necessary to interrupt the work and, more in detail, if you envisage
that the machine may remain unguarded, always disconnect the main switch.
IMPORTANT NOTICE
Do not start the shafts when the hopper is filled with material, but perform a
gradual loading at the beginning of each shift, after setting the shafts in operation
and from the recommended loading side. At the end of each shift,
remove/discharge all the material remaining in the hopper.
IMPORTANT NOTICE
Do not load any material into the hopper that is not listed in Table 1-1 – Technical
data and that is not mentioned in the Declaration and Warranty Certificate
attached. Processing different materials may impact on performance and damage
the machine.
6.2.1
Vessel substitution
DANGER
This operation must be carried out after having stopped the shredder and
following the instructions given in chapter 7 MAINTENANCE.
When the collection vessel placed under the shredder must be substituted, the operator must:
•
switch off the shredder by pressing the STOP BLADES button;
•
open the grid doors and change the vessel.
