INDUSTRIAL SHREDDER
Instruction manual for use and maintenance
MSM0005EN_
F
72 / 90
6.5.2
Reset after an emergency
To prepare the shredder for a new start:
•
check that the material collection vessel is empty;
•
check that the doors are closed so that the safety micro switches allow the machine to be
started;
•
check that the emergency push-button is released;
•
repeat the start operations already described on paragraph 6.2 STARTING SEQUENCE.
6.6
CLEANING AND PUTTING THE MACHINE OUT OF SERVICE
6.6.1
Cleaning of the shredder
The shredder does not need particular cleaning operations when used for treating "clean" materials
(e.g. plastic, wood, paper, aluminium etc. which do not contain polluting substances).
If on the contrary, sticky or resinous materials, or substances which could have a chemical reaction
and corrode the shredder's mechanical parts are treated, it will be necessary to clean the machine at
the end of each work shift.
To carry out this operation, it is necessary to run the machine and feeding it with inert material which,
passing through the blades, removes the residues of the previous working cycle.
Rags, paper, and sawdust, possibly soaked in lubricating oil may be profitably used to this purpose.
By checking the state of material coming out, the operator may establish whether the cleaning
operations have been sufficient or not.
6.6.2
Putting the machine out of service
Clean the machine, if necessary, as described above. At the end, disconnect the main switch, lock it
and disconnect the machine from the power mains.
6.6.3
Shredder removal and/or reallocation
IMPORTANT NOTICE
The operations must be carried out by skilled technicians who avail themselves
of the transport and handling means and systems already described in Chapter 4
INSTRUCTIONS FOR INSTALLATION.
If the shredder must be set aside in a place different from that of installation, proceed as follows:
•
Disconnect the machine from the power mains.
•
Disconnect the feeding cable from the switchboard terminals.
•
Dismantle the hopper.
•
Dismantle the shredding chamber from the stand and lubricate the blade surfaces with oil.
Cover it suitably.
