INDUSTRIAL SHREDDER
Instruction manual for use and maintenance
MSM0005EN_
F
79 / 90
7.3.3
Motion tests
In order to verify that the full reassembling has been properly made it is advisable to run the machine
shortly without hopper.
DANGER
The following operation is carried out with hopper dismantled, and therefore
without any protection: therefore the operator must pay the maximum attention
and ensure that that are no unauthorised persons in the work area. The operator
must also ensure that no tools or foreign materials have remained on the blades.
He must keep on distance when making the visual check and wear the proper
protections (glasses, safety helmet).
•
start the shredder and make it run in no-load conditions for a few minutes, checking no
interference among the blades, nor seizures and clearances are present.
•
switch off the shredder and disconnect it from the power supply mains once again.
7.3.4
Final settings
Re-tighten the first threaded ring on each shaft with the torque as follows and aligning one of the 4
insertion locations of the safety tab, and lock it.
To make the position of the location for tab insertion match, continue screwing up the threaded ring,
not unscrewing it.
Reassemble and tighten the second threaded ring on each shaft and lock it with the safety tab.
Check and re-tighten the stuffing rings fixing screws (version with additional seals, if installed).
Replace and fix the front cover (If installed).
Assemble the feeding hopper.
If everything is working perfectly, close the shredder definitively.
