INDUSTRIAL SHREDDER
Instruction manual for use and maintenance
MSM0005EN_
F
80 / 90
7.3.5
Replacing lubricating oils
First replacement:
after 200 working hours.
Maintenance replacements
: every 2500 working hours from the previous replacement, anyhow not
later than one year after the last replacement.
CAUTION
The shredder can be supplied either with or without oils, depending on transport
distances and specific agreement with the customer. The quantities reported in
the following table are indicative; proceed always filling until the level sign or plug
is reached.
For the Oil refer to paragraph
. Empty out the oil contained in the epicycle and gear reduction
units and in the bearings housing completely through the drain taps:
•
Wash out the gearboxes and the housing with clean oil;
•
Refill them again through the loading plugs.
7.3.6
Gears lubrication for series HDD GLADIATOR
EVERY 100 WORKING HOURS
Lubricate the gears adding 100 g of grease E.P. from the greasing point on the cover or removing the
cover (machine must be stopped). If it is too much, unloading the grease left on the box under the
gears.
IMPORTANT NOTICE
Please be sure that both gears are completely lubricated.
