INDUSTRIAL SHREDDER
Instruction manual for use and maintenance
MSM0005EN_
F
64 / 90
6.
SHREDDER OPERATION
At this point, once the first no-load run has been carried out and the relative checks and tests have
been made, the shredder is ready to be put into service.
CAUTION
For a correct machine running, it is advisable that the operator has read and
understood the instructions well. If doubts still exist, it is better to get in touch
with our Customer Assistance Service.
DANGER
The working areas, where the operator must work, are those between the
machine control panel, the material loading area and the unloading area. ANY
OTHER AREA IS OUTSIDE THE OPERATOR'S COMPETENCE.
DANGER
The operator in charge of the machine must be a worker specially skilled to run it
after having seen it or having been instructed on the modality of use of the
machine. The operator MUST NEVER INTERVENE on the machine for inspection
or maintenance operations which are the competence of qualified personnel.
To carry out the vessel substitution, the operator must stay away from the
supporting stand.
6.1
SHREDDER START
Check that the EMERGENCY push-button is released and that the shredded material collection vessel
is present inside the supporting stand.
Check that the door is closed so that the micro switch allows the shredder to be started.
6.1.1
Operation and alarm controls and indicators
The starting, adjustment and stop operations of the machine, including the alarm and proper operation
indicators, are controlled from the machine's switchboard. As regards the names of the components
which appear in the switchboard and their relative function, see the drawing of the switchboard front
and the table hereby shown.
