Operation Manual 5280 EPSP
51
8.1.2.7
Slightly unscrew the first screw on the left side of the clamping screw 2 (Fig. 31),
taking care that the screw head does not protrude above the knife beam sliding
plane.
8.1.2.8
Press the "Change knife" function on the programmer 4 (Fig.22)
8.1.2.9
Pressing the push buttons 2
(Fig. 33) at the same time, start the cutting cycle.
The knife will stop in the lower position.
8.1.2.10
. Switch off the power supply of the electrical system by turning the main switch
knob 3 (fig. 33) to the "0" position
Figure 32a.
8.1.2.11
. Screw in the bolt 2 lightly (fig.32a)
Figure 33.
