Operation Manual 5280 EPSP
58
8.4 Adjusting the parallelism of backguage
Depending on the required inclination of backguage, its adjustment should be carried out
using drawings 40 and 41,
Drawing. 40 Method for removing the cover
To adjust backguage:
1. unscrew the screws 1 (fig.40)
2. remove the cover 2 (fig.40)
3. loosen the screws 1 (fig.41)
4. loosen the nuts 2 (fig.41)
5. by turning the screws 3, place the approaching beam 4 (Fig. 41) at the right angle
6. lock the adjustment screws with 3 nuts 2 (fig.41)
7. firmly tighten the screws 1 (fig.41)
After the cutting attempt, repeat the adjustment until the parallel cutting is achieved.
