Operation Manual 5280 EPSP
8
1.2 Purpose of use
This Single knife cutter is designed for cutting to requested dimension reams of paper,
cardboard and other materials like pvc, plastics, fiber, foils, lamination and rubber etc. It is
mainly used by printing houses, print finishing specialists, copy shops and offices. In case of
some materials (like ex. plastics) it is recommended to use smaller ream than maximum
designed (to be consulted with manufacturer). The machine must be used according to the
rules given in operator manual and conditions as assemble, disassemble, reassemble,
installation, controlling and maintenance should be respected.
Danger of damage in case of wrong usage!
•
operator is fully responsible for any damages caused by incorrect using of the
machine!
•
the machine is designed only for purposes given in this manual by the
manufacturer!
1.3 Documentation
•
This operator manual is deliver with the machine
•
The operator manual is not the service manual.
•
It is a must to use only the original spare parts delivered by manufacturer or
authorized agent.
•
The drawings in the manual are example and may slightly differ from the real machine
received.
•
The maintenance substances mentioned in the manual like oils, greases etc. are
exemplary, available at manufacturer region when the manual was created. It is
allowed to use other materials with similar properties available at local market.
•
The manual should be always stored near the machine
•
The staff of user should be familiar with the manual before starting to operate the
machine.
1.4 Introduction
In this manual there are included information about safety features of the guillotine. The
manual should be stored near the machine and secured from lost or damage. It is necessary
to operate the machine according to manual but also to local, general rules of safety. The
