Operation Manual 7310 EPSHP
7
1.2 Purpose of use
This Single knife cutter is designed for cutting to requested dimension reams of paper,
cardboard and other materials like pvc, plastics, fiber, foils, lamination and rubber etc. It is
mainly used by printing houses, print finishing specialists, copy shops and offices. In case of
some materials (like ex. plastics) it is recommended to use smaller ream than maximum
designed (to be consulted with manufacturer). The machine must be used according to the
rules given in operator manual and conditions as assemble, disassemble, reassemble,
installation, controlling and maintenance should be respected.
Danger of damage in case of wrong usage!
•
operator is fully responsible for any damages caused by incorrect using of the
machine!
•
the machine is designed only for purposes given in this manual by the
manufacturer!
1.3 Documentation
•
This instruction manual is part of the product.
•
The operation manual is not the service manual.
•
Only use original spare parts.
•
The illustrations in the operating instructions may differ from the actual state of the
machine
•
The types of auxiliaries indicated in the operating instructions, such as oils, lubricants,
etc. refer to the means available on the market at the time of the instruction.
•
Always keep the complete technical documentation close to the machine.
•
We recommend that you carefully read this user manual before using the cutter.
1.4 Introduction
The manual contains special information about the machine's safety devices. Keep the
operating instructions close to the workplace and secure them against loss or damage. In
addition to the instructions, you must also follow the generally accepted standards and
applicable national regulations for occupational safety and accident prevention. The
employer is also obliged to adequately train service staff in accordance with the instructions.
Each operator must confirm the receipt of the operating instructions and undertake in writing
to comply with them. This requirement is necessary for the operator to start operating the
machine.
Summary of Contents for INT-GU-07310EPSHP
