Page 23 of 83
The following procedure should be used to install all IntraServer
CompactPCI
®
adapters:
1.
Turn OFF the power to the computer system, and to all
peripherals directly connected to the system (monitor, printer,
external SCSI enclosures, etc.)
2.
Unplug the system from the AC power line
3.
Use an anti-static strap or precautions to avoid static discharge
to your computer system or the IntraServer CompactPCI
®
adapter
4.
Remove the access cover for your system (refer to the
system’s documentation).
5.
Locate a free CompactPCI
®
expansion slot and remove the
screws and metal cover for the selected slot.
Be certain not to
install the adapter in a CPU slot
6.
Install the adapter in the selected slot. The module should fit
without forcing, and should line up with the I/O bulkhead. Be
certain that the adapter is fully seated in the slot.
7.
Tighten the retaining screws.
8.
Connect any SCSI devices to the SCSI connectors (see figure
1), following the guidelines in the “Configuring the SCSI
Bus” chapter of this manual.
9.
Plug your VGA monitor into the 15-Pin VGA port shown in
figure 1.
10.
Plug your network cables into the four network jacks, starting
from the top (qfe0) port.
