Open
-
Q
™
835 uSOM (APQ8098)
Development Kit
Your use of this document is subject to and governed by those terms and conditions (
https://www.intrinsyc.com/legal-terms/qualcomm-terms.html
) in the Intrinsyc Purchase and Software License Agreement for the Open-
Q™ 835 uSOM Development Kit based on the Qualcomm® Snap
drag-
on™ 835 Processor (APQ8098), which you or the legal entity you represent, as the case may be, accepted and agreed to when pur
chasing an Open-
Q™ 835 uSOM Development Kit from Intrinsyc Technologies Corporation (“Agreement”). You may use this document, which
shall be considered
part of the defined term “Documentation” for purposes of the Agreement, solely in support of your permitted use of the Open
-
Q™ 8
35 uSOM Development Kit under the Agreement. Distribution of this document is strictly prohibited without the express written permission of Intrinsyc Tech-
nologies Corporation and its respective licensors, which they can withhold, condition or delay in its sole discretion.
Intrinsyc is a trademark of Intrinsyc Technologies Corporation, registered in Canada and other countries. Qualcomm and Snapdragon are trademarks of Qualcomm Incorporated, registered in the United States and other countries.
Other product and brand names used herein may be trademarks or registered trademarks of their respective owners.
Package Contents
1.
WLAN/BT PCB Antenna
2.
Misc interface header (GPIO)
3.
Power button
4.
button
5.
Volume
-
button
6.
User LEDs (red, blue green)
7.
PCIe 1X Slot
8.
Sensor expansion header
9.
12V DC input jack
10.
Debug UART (USB MicroB)
11.
USB Type
-
C connector
12.
Battery charge config switch
13.
SOM Power voltage adjust
14.
Battery connector
15.
Power source switch
16.
HDMI video output
17.
Power header
18.
3.5 mm headset jack
19.
Configuration DIP switches
20.
MIPI camera 2 connector
21.
Micro SD slot (on bottom)
22.
MIPI camera 1 connector
23.
MIPI camera 0 connector
24.
Audio Out Expansion Header
25.
SOM power measurement
header
26.
Power and Charging LEDs
27.
Audio In Expansion Header
28.
Haptic output header
29.
WLAN PCB Antenna
30.
MIPI DSI LCD/touchscreen
connector to interface with
Intrinsyc display adapter
31.
UFS flash memory
32.
APQ8098 CPU with PoP RAM
33.
Wi
-
Fi RF section under shield
34.
WLAN antenna connector 1 U.FL
35.
WLAN antenna connector 2 U.FL
36.
Open
-
Q 835 µSOM
1.
Open
-
Q™ 835 µSOM with APQ8098 processor
2.
Open
-
Q™ 835 µSOM Carrier board
3.
AC Power Adapter
4.
HDMI Video Cable
5.
4.5” FWVGA MIPI DSI LCD/touchscreen (optional accessory)
1
3
4
10
12
16
20
22
24
2
5
13
27
9
19
18
23
30
31
33
34
35
32
29
25
11
26
36
28
21
6
7
8
14
15
17
