3
Removing the Battery Connector (FIGURE 5)
1. Remove the two (2) mounting screws and nuts
securing the battery connector to the motor shroud
as shown in FIGURE 5.
2. Carefully pull the battery connector away from the
motor shroud.
3. Loosen, but do not remove the two (2) flat screws
on the battery connector to release the YELLOW
(+) and BLUE (-) wires.
4. Pull the YELLOW (+) and BLUE (-) wires through
the motor shroud.
5. Remove the current limit device. Refer to REMOV-
ING CURRENT LIMIT DEVICE in this instruction
sheet.
Pendant
Cable
Spade Connector Wires
RED
Spade
Connector
BLACK Spade
Connector
Mounting
Bracket
Mounting Screws
Nut
Connection to
Motor Shroud
FIGURE 4 - REMOVING THE MOTOR SHROUD
- RELEASING THE CABLES
Removing Current Limit Device (FIGURE 6)
1. Remove the two (2) mounting screws and nuts se-
curing the current limit device to the motor shroud.
NOTE: EXISTING mounting screws and nuts will be
used to secure NEW current limit device to motor
shroud.
2. Remove the pendant/cable/current limit device as-
sembly.
3. Install NEW pendant/cable/current limit device as-
sembly. Refer to INSTALLING NEW CURRENT
LIMIT DEVICE in this instruction sheet.
Mounting
Screws
(Nuts NOT
SHOWN)
Battery
Connector
BLUE (-)
Wire
YELLOW (+) Wire
Flared End
FIGURE 5 - REMOVING THE BATTERY
CONNECTOR
STEPS 1 - 2
BLUE (-)
Wire
Battery
Connector
YELLOW (+) Wire
LOOSEN
Flat Screw
(DO NOT
REMOVE)
Bare
Wire
Insulated
Wire
DETAIL "A"
STEP 3
Motor
Shroud
