Part No. 1104849
125
3G Storm Series
®
Wheelchairs
B. Wheelchairs without vent tray -
Secure the top of shock to base frame.
Apply Loctite 242 and torque to 160 in-lbs.
8. Perform one (1) of the following sections:
A. FOR SHOCKS - Secure the NEW shock to the anti-tip bracket and suspension
arm with the existing mounting screw, two (2) large washers, two (2) short
spacers, and locknut. Torque to 13 ft-lbs.
B. FOR RUBBER ELEMENTS - Secure the NEW rubber element to the anti-tip
bracket and suspension arm with the existing mounting screw, two (2) large
washers, two (2) small washers, two (2) short spacers, one (1) 2-inch spacer and
locknut. Torque to 13 ft-lbs.
9. Reinstall the drive wheel from the wheel hub. Refer to REMOVING/INSTALLING
THE DRIVE WHEELS
in SECTION 12
of this manual.
10. Reinstall the group 24 battery boxes. Refer to REMOVING/INSTALLING BATTERY
BOXES
in SECTION 9 of this manual.
RWD WHEELCHAIRS
SECTION 15
WHEELCHAIRS EQUIPPED WITH
VENT TRAY
TOP OF SHOCK OR RUBBER ELEMENT
WHEELCHAIRS WITHOUT
VENT TRAY
FIGURE 5 - SHOCK OR RUBBER ELEMENT REPLACEMENT - GROUP 24
BATTERIES
Battery Box
Sub-frame
REAR
OF
CHAIR
FRONT
OF
CHAIR
Spacer
Mounting Screw
(LOOSEN)
Retainer Clip
(Closed End)
Top of
Shock
Battery Box Retainer Bar
Rearmost Mounting
Screws
(LOOSEN)
Battery Box
Sub-frame
Base
Frame
Spacer
RWD WHEELCHAIRS
