3G Storm Series
®
Wheelchairs
132
Part No. 1104849
REPOSITIONING THE STANDARD GEARLESS/BRUSHLESS
MOTOR - BEFORE 1/26/04 (FIGURES 12 AND 13)
NOTE: On models equipped with a fixed back only, the gearless/brushless motor can be
repositioned to lengthen or shorten the wheelbase by 2-inches in 1-inch increments.
ARROW AND RANGER X WITH
FIXED BACK
STANDARD POSITION - CENTERS the
wheelbase and gives you standard stability
and maneuverability.
1-INCH REARWARD- LENGTHENS the
wheelbase and gives you the most stability
and standard maneuverability.
1-INCH FORWARD - SHORTENS the
wheelbase and increases maneuverability
and distributes additional weight on rear
wheels.
ARROW, RANGER X, AND
TORQUE SP WITH WITH
MANUAL RECLINER, 2G
POWERED SEATING SYSTEM, OR
HIGH BACK VAN SEAT
STANDARD POSITION - LENGTHENS
the wheelbase and gives you the most
stability and standard maneuverability.
1-INCH FORWARD - CENTERS the
wheelbase and gives you standard stability
and maneuverability.
2-INCH FORWARD - SHORTENS the
wheelbase and increases maneuverability
and distributes additional weight on rear
wheels.
FIGURE 12 - ACCEPTABLE MOUNTING POSITIONS FOR THE
STANDARD GEARLESS/BRUSHLESS MOTOR - BEFORE 1/26/04
RWD WHEELCHAIRS
SECTION 15
1-inch forward -
Approximately 75%
of weight over
rear wheels
Standard -
Approximately 70%
of weight over
rear wheels
1-inch Rearward -
Approximately 65%
of weight over
rear wheels
1-inch Forward -
Approximately 70%
of weight over
rear wheels
2-inch Forward -
Approximately 75%
of weight over
rear wheels
Standard -
Approximately 65%
of weight over
rear wheels
FORWARD
RWD WHEELCHAIRS
