Part No. 1104849
29
3G Storm Series
®
Wheelchairs
SEAT FRAME
This Section Includes the Following:
Preparation for Removing/Installing Seat Frame (Standard Frame,
ASBA, and Van Seat)
Replacing Same Size Standard Seat Frame
Removing/Installing Standard Seat Frame Subassembly
Changing Seat Depth
Changing Seat Width (Standard and ASBA)
Installing/Removing ASBA Subassembly and/or Component Replacement
Installing/Removing Van Seat Assembly
Replacing Van Seat and/or Van Seat Frame
Converting From Standard Seat Frame to ASBA or Vice Versa
Converting From ASBA to Van Seat or Vice Versa
Converting From Standard Seat Frame to Van Seat or Vice Versa
Removing/Installing Seat Pan
Seat Angle Adjustment
WARNING
WARNING
WARNING
WARNING
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching hardware is tightened securely - otherwise injury or damage
may result.
NOTE: The procedures in this section of the manual refer to NON-RECLINER seat frames only,
EXCEPT Seat Angle Adjustment. For recliner seat frames, refer to SECTION 14 of this manual.
PREPARATION FOR REMOVING/INSTALLING SEAT
FRAME (STANDARD FRAME, ASBA, AND VAN SEAT)
(FIGURE 1)
NOTE: When installing/replacing components of the wheelchair, refer to the individual procedure
for correct use of LOCTITE 242 and torque specifications or SECTION 3 of this manual.
NOTE: To reinstall these components, reverse the following steps.
1. Remove footrest assemblies. Refer to INSTALLING/REMOVING FOOTRESTS in
SECTION 3 of the Owner’s Manual, part number 1104782 or 1123757.
2. Remove battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES
in
SECTION 9 of this manual.
SECTION 6
SEAT FRAME
