Part No. 1104849
87
3G Storm Series
®
Wheelchairs
SECTION 12
WHEELS/MOTORS
INSTALLING WHEEL LOCK BRACKET ONTO WHEELCHAIR
(FIGURE 5)
NOTE: This SECTION only pertains to wheelchairs with the conventional motor and gearbox.
On wheelchairs with the gearless/brushless motor, the wheel lock bracket is not required.
1. Remove the two (2) mounting screws closest to the large wheel that secure the
gearbox to the suspension arm.
2. Line up mounting holes in the wheel lock mounting bracket with the gearbox
mounting holes in the suspension arm.
3. Apply Loctite 242 to the two (2) mounting screws.
4. Reinstall the two (2) mounting screws into the mounting holes of the wheel lock
mounting bracket and gear box and torque to 75 in-lbs.
5. Repeat STEPS 1-4 for opposite wheel lock bracket.
6. Adjust the wheel locks. Refer to ADJUSTING WHEEL LOCKS in SECTION 9 of the
Owner’s Manual, part number 1104782 or 1123757.
WHEELS/MOTORS
Gearbox
Wheel Lock
Mounting
Bracket
Mounting
Screws
FIGURE 5 - INSTALLING WHEEL LOCK BRACKET ONTO WHEELCHAIR
Suspension
Arm