Set-up
7.
Release the Hi/Lo motor output shaft spring-loaded
coupler by pushing in against the Hi/Lo motor output
shaft spring-loaded coupler and turning clockwise.
The coupling will release and engage the foot
end top gear box output shaft cross pins.
8.
Ensure that all components are securely installed
WARNING!
Risk Of Damage
To avoid product damage:
– DO NOT open assemblies such as the
motors, pendant, junction boxes or gear
boxes. No user serviceable parts are
inside. Contact dealer or Invacare for
repair/replacement.
– Ensure gear box cover and all other
assemblies are closed.
– Unplug the power cord from its power
source before performing any maintenance
on the product. DO NOT unplug the power
cord from the junction box. Damage to
cord will result.
4.11
Inspecting the Bed
Electric Beds
WARNING!
Risk of Injury or Damage
To avoid injury or damage:
– When installing any connectors into the
junction box, be sure the cable lock is secure
after installation.
The following procedure is for full/semi-electric beds
only.
All motors, the junction box
B
, connectors
C
and wiring
are located on the foot spring section.
All connectors will arrive plugged into the junction box.
If a connector is not plugged into the junction box when
received or if a function of the bed is not working use the
color coding to check the placement of the connectors. Each
connector and junction box slot is color coded.
The color rings on the cables are not visible when the
cables are plugged in and the cable lock is attached.
1114836-H-05
27
Summary of Contents for 5307IVC
Page 47: ...Notes...
