Invacare® Homecare Beds
1.
Stand or prop each bed end in an upright position on
its legs.
2.
Using a mild soap/detergent and soft bristle brush or
sponge, scrub all exterior surfaces.
3.
Using a hose and nozzle attachment, rinse bed ends
thoroughly with plain cold or warm water.
Do not exceed a water temperature of 110° F.
Use household tap pressure. DO NOT use
pressure washers or steam cleaners.
DO NOT use solvents, bleach, alcohol, petroleum
products, caustic agents or highly alkaline or
acidic agents to clean the bed.
4.
Tip bed end from side to side to allow any collected
or trapped water to drain.
5.
Thoroughly towel dry bed end and all components.
6.
Repeat drying process until all components are dry.
Ensure that the bed end is completely dry before
storing.
Cleaning the Head and Foot Sections
WARNING!
Risk of Injury or Damage
The electric motors, control box and pendant
are NOT protected against the entrance of dust
and liquids.
– DO NOT spray liquids into any electrical
components.
– DO NOT wash head or foot section.
– DO NOT allow electrical components to get wet.
1.
Unplug the power cord of electric beds before
performing maintenance.
2.
Wipe down the bed with disinfectant. Allow it to dry
completely.
40
1114836-H-05
Summary of Contents for 5307IVC
Page 47: ...Notes...
