SECTION 1—GENERAL GUIDELINES
Part No 1114836
11
IVC
™
Bed Series
Electrical
DANGER
When using an extension cord, use only a three wire extension cord having at least
16 AWG (American Wire Gauge) wire and the same or higher electrical rating as
the device being connected. Use of improper extension cord could result in a risk of
fire and electric shock. Three prong to two prong adapters should not be used. Use
of three prong adapters can result in improper grounding and present a shock
hazard to the user.
NEVER operate if the unit has a damaged cord or plug. If it is not working properly, call
a qualified technician for examination and repair.
Keep all electrical cords away from heated or hot surfaces.
Ensure all cables and cords are routed such that they will not become entangled or
pinched. Otherwise damage or injury may result.
DO NOT unplug power cord from junction box.
The pendant and power cords must be routed and secured properly to ensure that the
cords DO NOT become entangled, pinched and/or severed during operation of the
electric bed.
NEVER operate the unit if these cords are damaged.
Refer servicing to qualified personnel only. Grounding reliability depends upon a
properly grounded wall outlet.
Repair or Service Information
DO NOT open assemblies such as the motors, pendant, junction boxes or gear boxes. No
user serviceable parts are inside. Only qualified technicians are permitted to repair these
parts. If unqualified individuals perform any work on these beds, the warranty is void.
Unplug the power cord from its power source before performing any maintenance on the
manual/electric bed. DO NOT unplug the power cord from the junction box. Damage to
cord will result.
The junction box is mounted to the foot motor with an actuator clip-lock. If replacing the
junction box, remove the actuator clip-lock and slide the junction box away from the foot
motor until it is free. Disconnect all cable connections.
Before connecting/disconnecting the connections at the junction box, make sure the cable
lock is removed by lightly depressing on the end tabs and lifting. After connectors are
plugged in, route all cables into the cable lock slots and snap the cable lock in place. When
installing any connectors into the junction box, be sure the cable lock is secure after
installation - otherwise, injury or damage may occur.
DO NOT force the connector into the junction box, otherwise - injury or damage may
occur.
